Wannabe Tombow Swifter
This mod is made with two Tombow ABT pens. They are quite expensive, but It sure is worth it. This pen is called Wannabe Tombow Swifter since it’s not exactly the same as the Tombow mod Swifter uses, but quite close to.
Pen Facts:
Length: 20 cm
Weight: As Com.ssa or a little lighter.
CoG: At the CoP
Required Pens: 2 Tombow ABT markers
Parts Needed:
1) Take of the caps and remove the “tips” on both sides.
2) Remove the back plug. It’s stuck quite hard, but if you pull hard enough it’ll loosen.
3) Poke out the inktube that’s inside through the back of the pen. Flush through some water to make sure no ink is left.
4) Cut the Back Plug so only the part that’s actually inside the pen + the border is left. When you’re done, press it back onto the back of the pen.
5) Put one of the big caps on both sides and add some Anyball Grip.
Finnished Product:
Pen Facts:
Length: 20 cm
Weight: As Com.ssa or a little lighter.
CoG: At the CoP
Required Pens: 2 Tombow ABT markers
Parts Needed:
- Tombow ABT Body
- 2 Big Tombow ABT Caps
- Dong-a Anyball Grip
1) Take of the caps and remove the “tips” on both sides.
2) Remove the back plug. It’s stuck quite hard, but if you pull hard enough it’ll loosen.
3) Poke out the inktube that’s inside through the back of the pen. Flush through some water to make sure no ink is left.
4) Cut the Back Plug so only the part that’s actually inside the pen + the border is left. When you’re done, press it back onto the back of the pen.
5) Put one of the big caps on both sides and add some Anyball Grip.
Finnished Product:
